This system is able to dispense up to 1 quart per minute when manually
operated, or up to 2 qts with an air or electric drive.
The Filler Flash is foot operated and will pump any flowable material
and can handle light abrasives.
A few of the advantages to owning a Michael Engineering / Rook Metering two part resin pump:
Saves time and Speeds production. . .
Michael Engineering’s Manual Metering Pumps provide the fastest way of measuring epoxy and urethane resins
available today. Simply operate the handle until you have the desired amount of two-part resin. Mix it together and
you're ready for work. No more sticky mix cups or scales.
Provides Accurate metering. . .
One ounce or a gallon, these machines quickly and accurately meters out just the right proportion of resin
andhardener. Precise measurement eliminates improperly cured batches associated with hand proportioning.
Saves resin three ways.
- Eliminates spills since pouring from containers is not needed.
- Since even tiny batches are now possible, making a little extra is eliminated.
- Counting the number of strokes of the handle assures accurate batch size estimation.
Reduces mess. . .
Resin goes where you want it to, not on benches, cans, tools, cups, hands, or clothes.
Pays for itself. . .
Large time and money savings experienced with our Dispensing equipment assures a higher than normal return on
investment. It Pays for itself in a short time, and then keeps on paying.
Easy to clean and service. . .
Simple construction allows quick, easy and economical cleaning and service.
Safe. . .
Keeps resin off clothes and body. Consequently, skin irritation problems are reduced or eliminated.
